Invacare Pronto M94 Owner's Manual page 37

ITEM
STATUS INDICATOR
MODES
Driving Screen
NOTE: For this procedure, refer to
FIGURE 5.7.
This screen is shown when the operator
issues a drive command and the Drive Icon
on the main screen was highlighted.
NOTE: The Drive's name, warning/info
message, status icon and battery indicator are
displayed on this screen.
Part No 1122145
The status indicator will show a "Warning" (exclamation point inside a triangle)
indicator when the chair has a condition that requires attention.
The status indicator will show a "STOP" sign when a serious condition exists. The
chair will not be allowed to operate.
The status indicator shows an Attendant Icon if the attendant's override switch is
active.
The dotted-box shows the area that contains the available "modes" in the cur-
rently selected drive. The modes are programmed for each drive and are based
upon the configuration of the chair.
These modes are highlighted when the Mode is active. The operator changes
modes by pressing the Mode Select Switch.
The available modes are as follows:
Drive Mode (1 through 4)
Automatic Positioning
Actuator Control Switch Mode (4-switch, 4-switch 2 levels, etc.)
ECU Output Activated (1 through 4)
RIM Mode Activated
Drive Select Mode Activated
No Driving
Available Modes in
this Drive (Must be
Programmed)
Icon appears when a
joystick command
will drive the
wheelchair
FIGURE 5.6 LCD Display Screens - Main Screen
SECTION 5—WHEELCHAIR OPERATION
DESCRIPTION
Drive Profile Name
Drive Indicator
Status/Info Message Area
FIGURE 5.7 LCD Display Screens - Driving
37
Battery Gauge Display
Status
ECU
Indicator
Screen
Pronto® M94™