Adjusting Seat Position On Seat Frame; Asba Model; Van Seat Model - Invacare Pronto M94 Owner's Manual

4. Reinstall mounting screw and locknut (FIGURE 7.5). Securely tighten.
5. Repeat STEPS 2-4 for the three (3) remaining adjustable height tubes.
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling UP on the latch bar.
6. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 41.

ADJUSTING SEAT POSITION ON SEAT FRAME

ASBA MODEL

DO NOT attempt to adjust the seat position of the ASBA seat on the seat frame.
This procedure MUST be performed by a qualified technician.

VAN SEAT MODEL

NOTE: For this procedure, refer to FIGURE 7.6 and FIGURE 7.7.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 41.
2. Remove the four (4) mounting screws and washers securing the seat assembly to the
seat frame (FIGURE 7.6).
3. Separate the seat assembly from the seat frame.
Seat Frame
Washer
Mounting Screws
FIGURE 7.6 - ADJUSTING SEAT POSITION ON SEAT FRAME
Part No. 1122145
WARNING
WARNING
43
SECTION 7—SEAT
Seat Assembly
Seat
Positioning
Strap
®
Pronto M94
™