Connecting; Disconnecting - Invacare Pronto M94 Owner's Manual

NOTE: For this procedure, refer to FIGURE 11.3 on page 74.

Connecting

1. Peel back battery terminal covers to expose battery clamp on each battery cable as
follows:
A. RED battery clamp cover from RED battery cable.
B. BLACK battery clamp cover from BLACK battery cable on front battery or GREY
battery clamp cover from BLACK battery cable on rear battery.
2. Using the mounting screws and nuts, secure the battery cables to the battery terminals
as shown in FIGURE 11.3 in the following order:
A. NEGATIVE (‐) BLACK battery cable to NEGATIVE (‐) battery terminal/post.
B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post.
3. Verify wiring harness is correctly installed and securely tightened.
4. Verify proper battery orientation.
5. Reposition battery terminal covers over battery post(s).
6. Using new tie‐wraps, secure the terminal covers to the battery terminals as shown in
FIGURE 11.3.
7. Repeat STEPS 1‐6 to install and connect the rear battery to the rear battery harness.

Disconnecting

1. Remove the existing tie‐wraps that secure the battery terminal covers to the battery
terminals.
2. Peel back battery terminal covers to expose battery clamp on each battery cable as
follows:
A. RED battery clamp cover from RED battery cable.
B. BLACK battery clamp cover from BLACK battery cable on front battery or GREY
battery clamp cover from BLACK battery cable on rear battery.
3. Remove the mounting screws and nuts that secure the battery cables to the battery
terminals as shown in FIGURE 11.3 in the following order:
A. POSITIVE (+) RED battery cable from POSITIVE (+) battery terminal/post.
B. NEGATIVE (‐) BLACK battery cable from NEGATIVE (‐) battery terminal/post.
4. Set wiring harness aside.
5. Repeat STEPS 1‐4 to disconnect the rear battery from the rear battery harness.
Part No 1122145
73
SECTION 11—BATTERIES
Pronto® M94™