Using/Adjusting The Clamp-On Wheel Locks - Invacare Tracer SX5 User Manual

12 RECLINER

12.7 Using/adjusting the Clamp-On Wheel Locks

Using the Clamp-On Wheel Locks
WARNING
DO NOT attempt to stop a moving wheelchair
with the wheel locks. WHEEL LOCKS ARE NOT
BRAKES.
 For this procedure, refer to FIGURE 7 on page 72.
The Tracer SX5 Recliner with 24-inch rear wheels
uses the disk wheel locks. Refer to Using/Adjusting
Patient Operated Wheel Locks on page 57.
1. Ensure the wheelchair is not moving before engaging the wheel
locks.
2. To engage, push the wheel lock handle forward.
3. Disengage the wheel locks by reversing STEP 2.
Adjusting the Clamp-On Wheel Locks
 For this procedure, refer to FIGURE 8 on page 73.
If wheels are pneumatic, before adjusting or replacing the wheel lock assemblies, ensure that the tires are inflated to the
recommended psi on the side wall of tire.
1. Disengage the wheel locks.
2. Loosen the bolt and locknut that secure the wheel lock to the wheelchair frame.
® ®
Invacare Tracer SX5 Wheelchair
FIGURE 7 Using/adjusting the Clamp-On Wheel Locks -
Using the Clamp-On Wheel Locks
72
Unlocked
Wheel Lock
Position
Locked
Position
Part No. 1110550