Section 7-Wheel Locks; Adjusting Wheel Locks - Invacare Action 5 Service Manual

S E C T I O N 7 — W H E E L L O C K S
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Ensure that the clamp assembly is well positioned in its frame located position.
Adjusting Wh eel Locks
NOTE: When changing the position of the rear wheels, the wheel locks MUST be repositioned.
NOTE: Before adjusting or replacing the wheel locks assemblies, ensure that the tires are inflated
to the recommended BAR, KPa, P.S.I on the sidewall of the tire.
Ad j u sti ng Wh e e l Lock P o s i ti o n
NOTE: For this procedure, refer to FIGURE 7.1.
1. Remove the two mounting screws (M6) that secures the wheel lock assembly to the
wheelchair frame.
2. Remove the wheel lock assembly from the clamp assembly.
3. Move the clamp assembly (if necessary) to the other wheel lock position on the
wheelchair frame.
4. Install the wheel lock assembly into the clamp assembly.
5. Secure the wheel lock assembly to the wheelchair frame with the two mounting screws
(M6).
6. Repeat STEPS 1 to 6 for the other wheel lock assembly.
Frame located
position
2 Mounting
screws (M6)
FIGURE 7.1
W A R N I N G
W heelchair
frame
Adjusting Wheel Locks - Adjusting Wheel Lock Position
3 7
SECTION 7—WHEEL LOCKS
Locking
screw (M4)
W heel lock
assembly