Seat And Back; Installing The Back Canes - Invacare Tracer SX5 User Manual

7 SEAT AND BACK

7 Seat and Back
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.

The procedures in this section apply to non-recliner models only. For recliner models, refer to Recliner on page 64
7.1

Installing the Back Canes

1. Remove the hex screw and locknut from the bottom of one back
cane.
2. Position threaded insert into the bottom of each back cane with nut
facing the outside of the wheelchair and aligned with the mounting
hole in the bottom of the back cane.
3. Insert the back cane into the mounting hole in the wheelchair frame.
4. Position the hex screw through the wheelchair frame, back cane,
and threaded insert.
The hex screw should be inserted from the inside

of the wheelchair frame.
5. Torque the hex screw to 60-80 inch pounds.
6. Install the locknut onto the hex screw. Secure the hex screw to prevent
it from backing out and torque the locknut to 60-80 inch pounds.
® ®
Invacare Tracer SX5 Wheelchair
Outside of
Wheelchair
Nut
Locknut
Wheelchair Frame
FIGURE 1
42
Back Cane
Threaded Insert
Hex Screw
Inside of
Wheelchair
Installing the Back Canes
Part No. 1110550
.