HP Integrity cx2600 Maintenance Manual page 97

PCI-X Bus, PCI-X Device, and PCI-X Function to the Bus #, Dev #, and Fnc #
values from the info io command.
CAUTION: Do not change the value for any of the following fields on the Adapter Properties
screen:
•
Auto Termination
•
SCSI Parity
•
SCSI Bus Scan Order
•
Spinup Delay (Secs)
Changing any of these fields can cause unpredictable results.
CAUTION:
Do not change the value for any of the following fields on the Device Properties
screen:
•
Scan Id
•
Scan LUNs > 0
•
Disconnect
•
SCSI Timeout
•
Queue Tags
•
Format
•
Verify
Changing any of these fields can cause unpredictable results.
7. Display the SCSI parameters listed below for the channel of the SCSI interface and change
the parameters if necessary, or restore its SCSI parameters to their default values.
• SCSI ID
• Maximum data transfer rate
• Bus width
• Whether the SCSI interface is bootable (driver support)
• Avoid bus resets (secondary cluster server)
• Restore Defaults
8. Use the arrow keys to navigate to the appropriate SCSI parameter.
9. Use the plus (+) and minus (-) keys to scroll through the values until the value you want
displays.
10. To exit the Adapter Properties screen, press Esc.
11. Move the cursor to the action (cancel, save, or discard) you want to take, and press
Enter. Select one of the following options:
• Cancel the exit to stay on the Adapter Properties screen for the channel of the SCSI
interface.
• Save the changes you made, then exit the screen.
• Discard the changes you made, then exit the screen.
If you select cancel, you remain in the Adapter Properties screen for the channel of the
SCSI interface. You can still change the channel's parameters.
If you select save or discard, you go to the EFI SCSI Setup Utility main menu.
CAUTION: Do not select the <Global Properties> option on the main menu.
12. To exit the main menu and the EFI SCSI Setup Utility, press Esc.
13. Select the option for exiting the utility.
14. When you are prompted, press Enter to stop the SCSI interface; you are now at the EFI Shell
prompt.
Specifying SCSI Parameters 97