HP Integrity cx2600 Maintenance Manual page 132

3. Remove the server from the rack and place it on an ESD-protected work surface. See
"Removing the Server From a Rack" (page
WARNING!
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
to follow ESD safety precautions can result in damage to the server.
4. Remove the top cover from the chassis. See
(page 123).
5. Pull up on the PCI card cage release lever and the back edge of the card cage.
Figure 7-14 Removing the PCI-X Card Cage
Release
6. Lift straight up on the card cage without rocking to remove it from the server chassis.
7. Place the card cage on an ESD-protected work surface.
8. Orient the card cage so that PCI card connectors within the card cage are at the bottom,
when viewed through the open side of the card cage.
9. Remove the cards by lifting them from the sockets.
10. Remove the cover that is now on top of the PCI card cage by sliding the cover toward the
rear of the card cage and lifting the cover to remove the cover from the card cage.
132 Removing and Replacing Components
Ensure that the system is powered off and all power sources are disconnected
Observe all ESD safety precautions while performing this procedure. Failure
PCI Card Cage
Lever
chaspciccdwn
115).
"Removing and Replacing the Top Cover"