HP Integrity cx2600 Maintenance Manual page 164

1. If rack-mounted, extend the server out from the rack until it stops. See
When the Server Is in a Rack" (page
2. Power off the server. Disconnect all external cables.
3. Remove the server from the rack and place it on an ESD-protected work surface. See
"Removing the Server From a Rack" (page
4. Remove the chassis top cover. See
5. Remove all airflow guides. See
6. Remove the PCI-X card cage. See
7. Loosen the five captive screws (T-15) that secure the center support member separating the
PCI-X cage compartment from the system board area to the chassis
the cable harness attached to the support member and remove the support member from
the server chassis.
Figure 7-47 Removing the Center Support Member
8. Remove the CPU processors. See
9. Remove the DIMM memory modules. See
DIMMs" (page
10. Remove the MP card. See
11. Label and disconnect all cables connected to the system board.
12. On the rear panel of the server chassis, remove the noncaptive screws and connector hardware
securing the following connectors:
• SCSI LVD (left) (hex 143-IN-LG 4-40 stainless steel)
• Serial A Console (right) (two screws - hex 2-56 w/slot stainless steel)
• Serial B (below Serial A console) (two screws - hex 2-56 w/slot stainless steel)
164 Removing and Replacing Components
114).
"Removing and Replacing the Top Cover" (page
"Removing and Replacing Airflow Guides" (page
"Removing and Replacing the PCI Card Cage " (page
"Removing and Replacing a System Processor" (page
128).
"Removing the Management Processor Board" (page
115).
"Removing and Replacing System Memory
"Installing Components
123).
127).
131).
(Figure 7-47). Remove
147).
146).