Configuring Basic Rip; Enabling Rip - HP 5500 EI series Configuration Manual

Tasks at a glance
(Optional.)
•
Configuring an additional routing metric
•
Configuring RIPv2 route summarization
•
Disabling host route reception
•
Advertising a default route
•
Configuring received/redistributed route filtering
•
Configuring a preference for RIP
•
Configuring RIP route redistribution
(Optional.)
•
Configuring RIP timers
•
Configuring split horizon and poison reverse
•
Configuring the maximum number of ECMP routes
•
Enabling zero field check on incoming RIPv1 messages
•
Enabling source IP address check on incoming RIP updates
•
Configuring RIPv2 message authentication
•
Specifying a RIP neighbor
•
Configuring RIP network management
•
Configuring the RIP packet sending rate
•
Setting the maximum length of RIP packets
(Optional.)
(Optional.)
(Optional.)

Configuring basic RIP

Before you configure basic RIP settings, complete the following tasks:
Configure the link layer protocol.
•
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.

Enabling RIP

To enable multiple RIP processes on a router, you must specify an ID for each process. A RIP process ID
has only local significance. Two RIP routers having different process IDs can also exchange RIP packets.
If you configure RIP settings in interface view before enabling RIP, the settings do not take effect until RIP
is enabled. If a physical interface is attached to multiple networks, you cannot advertise these networks
in different RIP processes. You cannot enable multiple RIP processes on a physical interface.
Enabling RIP on a network
You can enable RIP on a network and specify a wildcard mask for the network. After that, only the
interface attached to the network runs RIP.
To enable RIP on a network:
Configuring RIP route control:
Tuning and optimizing RIP
Configuring RIP GR
Configuring BFD for RIP
Configuring RIP FRR
networks:
23