Display Rip Route - HP 6125XLG Command Reference Manual

Field
Default route
Default route cost
Current number of packets /Maximum
number of packets

display rip route

Use display rip route to display routing information for a RIP process.
Syntax
display rip process-id route [ ip-address { mask | mask-length } | peer ip-address | statistics ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
ip-address { mask | mask-length }: Displays route information for the specified IP address.
peer ip-address: Displays route information learned from the specified neighbor.
statistics: Displays route statistics, including the total number of routes and number of routes from each
neighbor.
Examples
# Display all routing information for RIP process 1.
<Sysname> display rip 1 route
Route Flags: R - RIP
----------------------------------------------------------------------------
Peer 1.1.1.2 on Vlan-interface12
Destination/Mask
2.0.0.0/8
A - Aging, S - Suppressed, G - Garbage-collect
Nexthop
1.1.1.2
Description
Indicates whether to send a default route to RIP neighbors:
•
Only—Advertises only a default route.
•
Originate—Advertises both a default route and other routes.
•
No-originate—Advertises only non-default routes.
•
Off—Advertises no default route.
Metric for a default route.
Number of RIP packets to be sent/maximum number of RIP packets
that can be sent within a certain interval.
Cost
1
36
Tag Flags Sec
0 RA 14