Transmit-Pacing; Vlink-Peer (Ospf Area View) - HP 6125XLG Command Reference Manual

transmit-pacing

Use transmit-pacing to configure the maximum number of LSU packets that can be sent at the specified
interval.
Use undo transmit-pacing to restore the default.
Syntax
transmit-pacing interval interval count count
undo transmit-pacing
Default
An OSPF interface sends up to three LSU packets every 20 milliseconds.
Views
OSPF view
Predefined user roles
network-admin
Parameters
interval interval: Specifies an interval at which an interface sends LSU packets, in the range of 10 to
1000 milliseconds. If the router has multiple OSPF interfaces, increase this interval to reduce the total
number of LSU packets sent by the router every second.
count count: Specifies the maximum number of LSU packets sent by an interface at each interval, in the
range of 1 to 200. If the router has multiple OSPF interfaces, decrease the maximum number to reduce
the total number of LSU packets sent by the router every second.
Examples
# Configure all the interfaces running OSPF process 1 to send up to 10 LSU packets every 30
milliseconds.
<Sysname> system-view
[Sysname] ospf 1
[Sysname-ospf-1] transmit-pacing interval 30 count 10

vlink-peer (OSPF area view)

Use vlink-peer to configure a virtual link.
Use undo vlink-peer to remove a virtual link.
Syntax
vlink-peer router-id [ dead seconds | hello seconds | { hmac-md5 | md5 } key-id { cipher cipher-string
| plain plain-string } | retransmit seconds | simple { cipher cipher-string | plain plain-string } |
trans-delay seconds ] *
undo vlink-peer router-id [ dead | hello | { hmac-md5 | md5 } key-id | retransmit | simple |
trans-delay ] *
Default
No virtual link is configured.
130