HP 6125XLG Command Reference Manual page 46

Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
interface-type interface-number: Specifies an interface by its type and number. If no interface is specified,
the command displays information about all RIP interfaces for the RIP process.
Examples
# Display information about all interfaces for RIP process 1.
<Sysname> display rip 1 interface
Interface: Vlan-interface12
Address/Mask: 1.1.1.1/24
MetricIn: 0
MetricOut: 1
Split-horizon/Poison-reverse: On/Off
Default route: Off
Current number of packets/Maximum number of packets: 0/2000
Table 10 Command output
Field
Interface
Address/Mask
Version
MetricIn
MetricIn route policy
MetricOut
MetricOut route policy
Split-horizon
Poison-reverse
Input/Output
Version: RIPv1
MetricIn route policy: Not designated
MetricOut route policy: Not designated
Input/Output: On/On
Description
Name of an interface running RIP.
IP address and mask of the interface.
RIP version running on the interface.
Additional metric added to incoming routes.
Name of the routing policy used to add an additional metric for
incoming routes. If no routing policy is used, the field displays Not
designated.
Additional metric added to outgoing routes.
Name of the routing policy used to add an additional routing metric
for outgoing routes. If no routing policy is used, the field displays Not
designated.
Indicates whether split horizon is enabled:
•
on—Enabled.
•
off—Disabled.
Indicates whether poison reverse is enabled:
•
on—Enabled.
•
off—Disabled.
Indicates whether the interface is enabled to receive and send RIP
messages:
•
on—Enabled.
•
off—Disabled.
35