Configuring Synchronous Information Output; Disabling An Interface From Generating Link Up/Down Logging Information - HP 6125G Configuration Manual

Step
5. Configure a system
formation output
rule for the Web
interface.
6. Configure the
format of the time
stamp.

Configuring synchronous information output

The output of system logs interrupts ongoing configuration operations, and you have to find the
previously input commands before the logs. Synchronous information output can show the previous input
after log output and a command prompt in command editing mode, or a [Y/N] string in interaction
mode so you can continue your operation from where you were stopped.
If system information, such as log information, is output before you input any information under the
current command line prompt, the system does not display the command line prompt after the system
information output.
If system information is output when you are inputting some interactive information (non Y/N
confirmation information), the system displays your previous input in a new line but does not display the
command line prompt.
To enable synchronous information output:
Step
1. Enter system view.
2. Enable synchronous
information output.
Disabling an interface from generating link
up/down logging information
By default, all interfaces generate link up or link down log information when the state changes. In some
cases, you might want to disable specific interfaces from generating this information. For example:
You are concerned only about the states of some interfaces. In this case, you can use this function
•
to disable other interfaces from generating link up and link down log information.
An interface is unstable and continuously outputs log information. In this case, you can disable the
•
interface from generating link up and link down log information.
To disable an interface from generating link up/down logging information:
Step
1. Enter system view.
Command
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level severity |
state state }* | log { level severity | state
state }* | trap { level severity | state
state }* ]*
info-center timestamp { debugging | log |
trap } { boot | date | none }
Command
system-view
info-center synchronous
Command
system-view
46
Remarks
Optional.
See "Default output rules of system
information."
Optional.
The time stamp format for system
information is date by default.
Remarks
N/A
Disabled by default
Remarks
N/A