Configuring Ntp Client/Server Mode With Authentication - HP 6125G Configuration Manual

Network management and monitoring configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

[DeviceB] interface vlan-interface 2
[DeviceB-Vlan-interface2] pim dm
[DeviceB-Vlan-interface2] quit
[DeviceB] vlan 3
[DeviceB-vlan3] port gigabitethernet 1/0/1
[DeviceB-vlan3] quit
[DeviceB] interface vlan-interface 3
[DeviceB-Vlan-interface3] igmp enable
[DeviceB-Vlan-interface3] igmp static-group 224.0.1.1
[DeviceB-Vlan-interface3] quit
[DeviceB] interface gigabitethernet 1/0/1
[DeviceB-GigabitEthernet1/0/1] igmp-snooping static-group 224.0.1.1 vlan 3
Configure Device A:
5.
<DeviceA> system-view
[DeviceA] interface vlan-interface 3
# Configure Device A to operate in multicast client mode and receive multicast messages on
VLAN-interface 3.
[DeviceA-Vlan-interface3] ntp-service multicast-client
# Display the NTP status of Device A after clock synchronization.
[DeviceA-Vlan-interface3] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 40.00 ms
Root dispersion: 10.83 ms
Peer dispersion: 34.30 ms
Reference time: 16:02:49.713 UTC Sep 19 2005 (C6D95F6F.B6872B02)
The output shows that Device A has synchronized to Device C because it has a higher stratum than
Device C.
# Display NTP session information for Device A.
[DeviceA-Vlan-interface3] display ntp-service sessions
**************************************************************************
[1234] 3.0.1.31
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations :
The output shows that an association has been set up between Device A and Device C.

Configuring NTP client/server mode with authentication

Network requirements
As shown in
Configure Device B to operate in client mode and use Device A as its NTP server.
source
reference
127.127.1.0
1
Figure
15, configure Device A as a reference source, with the stratum level 2.
stra
reach
poll
2
255
64
28
now
offset
delay
26
-16.0
40.0
disper
16.6

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents