MAX
STEP 2:
Turn machine on, increase speed until 1.2 mph
shows on display,
the display shows exactly 1.0 mph.
STEP 3:
Adjust "MIN" pot on KBLC-118 until belt
speed is between
8.8 - 9.3 rpm counting belt revolutions.
STEP 4:
Turn speed up to 8.8 mph ( on display ),
then slowly increase
exactly 9.0 mph.
STEP 5:
Adjust "MAX" pot on the KBLC-118 until the belt
speed is between
83.0 - 83.4 rpm ).
STEP 6:
Since the "MAX" and "MIN" pots will affect each
other during the
steps 2 - 5 several times.
needs readjustment.
Appendix 2:
Note:
The elevation system will need to
be re - calibrated:
1.
motor.
2.
potentiometer.
3.
inaccurate.
STEP
Remove the two screws holding the elevation
1:
potentiometer
and pull the pot from the back of the
elevation motor.
STEP
Turn the treadmill on in the diagnostic
2:
mode by holding down the " Select
MIN
then slowly decrease speed just until
0.95 - 1.00 mph using a tachometer OR
speed just until display shows
8.95 - 9.00 mph ( or
adjustment, it may be nessary to repeat
Continue calibration until neither pot
Elevation System Calibration
After replacing the elevation
After replacing the elevation
If the elevation readout appears
IR
CL
75