Stapling A Print Job; Punch; Creating Punch Holes For A Print Job - Kyocera TASKalfa 2551ci Driver Manual

Stapling a Print Job

1
2
3
4
5

Punch

Creating Punch Holes for a Print Job

Printer Driver
maximum number of sheets depends upon the finisher model and the selected
Page size or Media type. The Gutter feature lets you increase the top and left
margins to accommodate the location of the staples.
Staple and Separation features cannot be used together.
If Printer default is selected as the Destination in the Basic tab, the selection
of an option in the Finishing tab results in the automatic selection of a
destination compatible with that finishing option. The destination is
automatically updated to the first available output tray that supports the selected
finishing option.
Staple selects the Destination automatically. If the Finishing options are
changed, the Destination selection is not affected.
Finishing edge should be selected before any other features in the Finishing
tab. If set last, Finishing edge might change any settings that you previously
made under Staple.
With a finishing device installed, you can create stapled document sets.
In the Finishing tab, click the Staple icon.
Select the position from available options. The position options vary based on
settings in Finishing edge, which provides custom staple locations in the
document.
Select the count for stapling:
Under Count, select the number of sheets for each stapled set, or select All
to staple all sheets.
Click OK to return to the Print dialog box.
Click OK to start printing.
The Punch feature places punched holes along the edge of the printed pages
so that the pages can be bound together or placed in a binder.
Punch is enabled when a finisher that supports punch is selected in Device
options in Device Settings. When you select the check box for a finishing
device shown in blue in the Device options list, the Punch Unit Settings
dialog box appears. If the device listing is already selected, double-click the
option to open the Punch Unit Settings dialog box.
Punch cannot be used when Booklet is selected in the Layout tab.
Finishing edge should be selected before any other features in the Finishing
tab. If set last, Finishing edge might change any settings that you previously
made under Punch.
The finishing device must support the Punch feature.
Available punch options are set in Device Settings and depend on the punch
unit installed on the device and selected.
Finishing
7-5