DATA BAND
Select how data will be transmitted and received on your
transceiver.
1 Enter Menu mode and access Menu 529.
2 Set the data band to A-BAND (A band receives and
transmits), B-BAND (B band receives and transmits),
TX:A-BAND RX:B-BAND (A band transmits (
B band receives (
band receives (
) and B band transmits (
COM PORT SPEED
You can adjust the speed at which the computer and
transceiver exchange information, when the transceiver is
connected to your computer.
1 Enter Menu mode and access Menu 528.
2 Set the COM port speed to 9600, 19200, 38400, or
57600 bps.
•
Turning the power ON/OFF will change the port speed
setting.
USING EXTERNAL TNC
■ External Data Band
1 Enter Menu mode and access Menu 517.
2 Set the data band to A-BAND (A band receives
and transmits), B-BAND (B band receives and
transmits), TX:A-BAND RX:B-BAND (A band
transmits and B band receives), or RX:A-BAND TX:
B-BAND (A band receives and B band transmits).
)), or RX:A-BAND TX:B-BAND (A
■ DATA Terminal Speed
Select 1200 or 9600 bps for the data transfer rate,
depending on TNC.
1200 bps: Transmit data input (PKD) sensitivity is 40
mV
, and input impedance is 10 kΩ.
p-p
9600 bps: Transmit data input (PKD) sensitivity is 2
V
, and input impedance is 10 kΩ.
p-p
1 Enter Menu mode and access Menu 518.
) and
)).
2 Set the data speed to 1200 or 9600 bps.
■ PC Port Speed
1 Enter Menu mode and access Menu 519.
2 Set the PC port speed to 9600, 19200, 38400, or
57600 bps.
•
Turning the power ON/OFF will change the port speed
setting.
■ SQC Output Setting
You can set the condition for which the SQC output
terminal becomes active.
1 Enter Menu mode and access Menu 520.
2 Set the SQC output activation method to one of the
following:
•
OFF: SQC output remains inactive.
•
BUSY: When a signal is received on the data band,
the SQC output becomes active.
•
SQL: While CTCSS/DCS is ON and a matching
signal is received, the SQC output becomes active.
While CTCSS/DCS is OFF, the SQC output becomes
active when a busy signal is received.
•
TX: While transmitting, the SQC output becomes
active.
•
BUSY.TX: When the conditions of BUSY and TX
(above) are met, the SQC output becomes active.
•
SQL.TX: When the conditions of SQL and TX (above)
are met, the SQC output becomes active.
Note: The activation type (logic) can be changed using the MCP-
2A software ([Edit] - [Data Terminal] - [SQC Output Logic]).
PACKET-2