Kenwood TM-D710A (K type) Instruction Manual page 38

Command Name Short
KISS KISS
LCSTREAM LCS
LIST LI
LOCATION LOC
LOG LOG
LPATH LPA
LTEXT LT
LTMON LTM
MAIL MAI
MAXFRAME MAX
MBOD MB
MCOM MCOM
MCON MC
MINE MI
MONITOR M
MRPT MR
MSTAMP MS
MYALIAS MYA
MYCALL MY
MYMCALL MYM
NEWMODE NE
NOMODE NO
Description
When ON, entering a RESTART command causes the
TNC to enter (or exit) KISS mode.
When ON, changes a small letter (a through z) entered
as a stream designator, to a capital letter (A through
Z). A stream designator must be entered immediately
after STREAMSW.
Displays the list of messages, in the TNC mailbox,
other than those addressed to other stations.
If set to EVERY, sends GPS data at intervals of the
specified period (n). If set to AFTER, sends GPS data
only once after the specified period (n). The unit of n
is 10 seconds.
Displays the list of stations which have connected to
the TNC mailbox.
Specifies callsigns to send GPS data. Call1 is the
callsign of the destination. Call2 to call9 are callsigns
of stations to be digipeated through.
Specifies the content of a message to be included in
GPS data.
Specifies the interval for displaying a message
determined by LTEXT on the screen; a message
appears like a received beacon packet. The unit of the
parameter is 1 second.
When ON and the TNC mailbox holds a message
addressed to you, outputs "Low" to the MAILLED
terminal.
Specifies the maximum number of packets to be
transmitted at one time.
When ON, allows the TNC mailbox to be used.
When ON, causes the TNC to also monitor control
packets. When OFF, causes it to monitor only
information packets.
When ON, causes the TNC to monitor other stations
while in connection with the target station.
Displays the list of messages, in the TNC mailbox,
addressed to you and messages that you sent.
When ON, causes the TNC to monitor packets.
When ON, causes the TNC to display the entire
digipeat list for monitored packets.
When ON, causes the TNC to display data and time
information for monitored packets.
Specifies a callsign for using your station as a
digipeater.
Specifies your callsign.
Specifies a callsign to be assigned to your TNC
mailbox.
When ON, entering a CONNECT command causes
the TNC to immediately enter the other mode.
When ON, does not cause the TNC to automatically
enter the other mode. When OFF, causes it to
automatically enter the other mode as specified by
NEWMODE.
PACKET-5
Parameter Default
ON/ OFF OFF
ON/ OFF ON
−
EVERY/ AFTER
n EVERY 0
(n = 0 ~ 250)
−
Call1 (VIA call2,
GPS
call3, ... call9)
0 ~ 159
characters
0 ~ 250
ON/ OFF OFF
1 ~ 7
ON/ OFF OFF
ON/ OFF OFF
ON/ OFF OFF
−
ON/ OFF ON
ON/ OFF ON
ON/ OFF OFF
6 characters +
SSID
6 characters +
SSID
6 characters +
SSID
ON/ OFF OFF
ON/ OFF OFF
−
−
−
0
4
−
−
−
−