Kenwood TM-D710A (K type) Instruction Manual page 63

There are 4 types of transceiver reset available:
VFO Reset
Use to initialize the VFO and accompanying settings.
PARTIAL (Partial) Reset
Use to initialize all settings other than the Memory channels, the DTMF memory, and the PM channels.
PM Reset
Use to reset only the Programmable Memory channels to their default values.
FULL Reset
Use to initialize all transceiver settings that you have customized.
There are 2 ways to perform a reset on the transceiver: by key operation and by accessing Menu mode.
KEY OPERATION
1 Turn the transceiver power OFF.
2 Press [F] + Power ON.
3 Rotate the Tuning control and select your desired
reset type: VFO RESET, PARTIAL RESET, PM
RESET, or FULL RESET.
4 Press the Tuning control to set the reset type.
• A confirmation message appears on the display.
• Press [BACK] to return to the previous display or [ESC]
to cancel the reset.
5 Press the Tuning control again to perform the reset.
Note: When in Remote Control or Repeater mode, you cannot reset
the transceiver using the Key Operation method.
TRANSCEIVER RESET
(Date and time are not reset.)
MENU MODE
1 Enter Menu mode and access Menu 999.
2 Set the reset type to VFO RESET, PARTIAL RESET,
PM RESET, or FULL RESET.
3 Press the Tuning control to set the reset type.
•
•
4 Press the Tuning control again to perform the reset.
Note: When the Channel Display function or Key Lock function is
ON, the transceiver reset cannot be performed.
RESET-1
A confirmation message appears on the display.
Press [BACK] to return to the previous display or [ESC]
to cancel the reset.