Troubleshooting Procedure (Continued)
Step
Actions and Questions
6
1.
Measure the voltage between the
engine control interface board and
J533A-9 and frame ground.
2.
Does the voltage measure +5 VDC?
7
1.
Measure the voltage between the
engine control interface board and
J533A-10 and frame ground.
2.
Does the voltage measure +5 VDC?
8
1.
Remove the accumulator belt
assembly.
2.
Enter service diagnostics and run the
Steering Motor test.
3.
Does the motor turn?
9
1.
Measure the voltage between the
engine control interface board J550-5
and frame ground.
2.
Is the voltage +24 VDC?
10
1.
Measure the voltage between the
engine control interface board J550
Pins 1, 2, 3, 4 and frame ground.
2.
Is the voltage +24 VDC?
Error Messages and Codes
Yes
Go to step 7.
Replace in the
following order:
engine control
interface board
engine control
board
Replace the
accumulator belt
assembly.
If the problem is
unresolved
replace the engine
control board.
Go to step 10.
Replace in the
following order:
engine control
interface board
engine control
board
No
Replace in the
following order:
engine control
interface board
engine control
board
The edge sensor
is defective,
replace the
accumulator belt
assembly.
Go to step 9.
Replace in the
following order:
engine control
interface board
engine control
board
Replace the
steering drive
assembly.
3-23