Xerox 7750DXF - Phaser Color Laser Printer Service Manual page 238

Recharging a Developer Housing Assembly
Caution
If replacing a developer housing assembly, write down the new ATC tag
number. Remove the tear-off ATC tag number label, and adhere it near the
appropriate Imaging Unit connector on the Imaging Unit plate assembly,
then perform the procedure. See "ATC Sensor Setup" on page 6-14.
Note
It is easy to spill toner in this procedure. Use only a type II toner vacuum to
clean up any spilled toner.
Check the temperature sensitive label on the developer beads. If the label has
turned dark, the beads have been exposed to a higher than expected
temperature and should not be used.
If the developer beads are being replaced for toner clumping, also replace the
toner cartridge of the effected color. The dispense assembly of the effected
color should also be purged of all toner before the new toner cartridge is
installed.
Note Wire Routing
Under Tab
8-26
Spill Caution
Magnetic
Roller
Phaser 7750 Printer Service Manual
Release Tabs
Protective Paper
Developer
S7700-179