Xerox 7750DXF - Phaser Color Laser Printer Service Manual page 245

Accumulator Belt Mounting Frame
1. Remove the accumulator belt assembly.
2. Remove the imaging units and protect from light.
3.
Remove the imaging unit plate cover.
4.
Remove the steering drive assembly.
5.
Remove the fuser.
6. Remove the registration assembly.
7. Remove the mounting screws from the main drive assembly and push it 1/4 inch
to the rear of the printer.
8.
Remove 4 black screws that mount the accumulator belt frame to the left hand lift
jack.
9. Remove the e-clips and washers from the right hand lift jack roller guides.
10.
Remove the 4 black screws holding the right hand lift bracket to the Accumulator
Belt Frame and remove the bracket.
11. Remove the 1 screw holding the accumulator belt connector to the rear frame and
move the harness out to the way.
12.
Remove the 2 screws holding the first bias transfer contacts to the rear frame and
move them out of the way.
13.
Remove the guide studs on the front and rear of the printer.
14.
Unhook the erase lamps mounted on each guide rail and remove the guide rails.
15.
Raise the front handle.
16. Lift the accumulator belt frame assembly as high as it goes and remove it from
the right side of the printer.
Service Parts Disassembly 8-33