Ford Probe Owner's Manual page 79

Raising the Headlamps Manually
If the power headlamp door system becomes
inoperative, your vehicle has a manual retractor
system that allows you to raise the headlamps
manually (the headlamps will not turn on). The
retractors are located under the hood and behind
each headlamp. Remove the cap and turn the
knob. Each headlamp must be raised separately.
Before using the manual retractors to raise your
headlamps, the RETRA fuse must be removed.
Open the main fuse panel. Refer to the
underhood fuse panel in Servicing Your Probe
later in this owner guide. Pull the RETRA (20A)
fuse straight out.
Inspect the removed fuse. If it is blown, replace
it with a new one of the same rating. If it isn't
blown or if a new fuse does not solve the
problem, remove it and operate the headlamp
manually.
Always remove the RETRA (20A) fuse
before manually operating a headlamp
retractor or attempting to remove anything
from the headlamp. Failure to remove the
RETRA fuse could cause injury to a hand
or fingers.
When reinstalling the RETRA fuse, make
sure nothing is near the headlamp
retractor. It may move suddenly while the
fuse is being inserted, causing injury to
hands and fingers.
RWARNING
RWARNING
79