Ford Probe Owner's Manual page 124

Using the "SCAN/TUNE" button to scan
radio stations
Pressing the "SCAN/TUNE" button once
enters the scan mode (display will indicate
"SCN"). Pushing the top a half of the
"SEEK" button will begin the scan mode up
the frequency band, stopping on each
listenable station for approximately five
seconds. Pushing the bottom b half of the
"SEEK" button will begin the scan mode
down the frequency band, again stopping on
each listenable station for approximately five
seconds.
To stop the scan mode on the presently
sampled station press the "SCAN/TUNE"
button again.
Setting the Station Memory Preset buttons
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
FM stations (5 in FM1 and 5 in FM2). Follow
the easy steps below to set these buttons to
the desired frequencies.
1. Select a band, then select a frequency.
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
3. Follow the two steps above for each station
memory preset button you want to set.
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
124