Installing A Compactflash Memory Card - Cisco 2900 series Installation Manual

Chapter 5 Installing and Upgrading Internal Modules and FRUs
Figure 5-52
Step 4 Press the ejector button again. See
of its slot.
Pull the CF memory card out of its slot.
Step 5
Step 6 Push the ejector button in until the button is flush with the bezel.
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
Caution
against the bezel) when not being used to eject a CompactFlash memory card.

Installing a CompactFlash Memory Card

To install a CompactFlash memory card, perform the following steps (see
Step 1 Read the
any module replacement.
Make sure that the ejector button is fully seated until it is flush with the bezel.
Step 2
Note
Step 3 Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains
flush with the panel.
Note
To prevent damage to the ejector mechanism, the ejector button must remain fully seated when not being
Caution
used to eject a CompactFlash memory card.
OL-18712-03
CompactFlash Memory Card Slot in Cisco 2900 Series Routers
DO NO T
RE MO VE
DU RI NG
D O N O T NE TW OR
R E M O V K OP ER
AT IO N
E D U R IN
N E TW O
R K O P E G
R AT IO N
1
2
"Safety Warnings" section on page 5-2
If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
If the ejector button is projecting from the panel after you insert the CompactFlash memory card,
remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the
CompactFlash memory card.
Removing and Installing CompactFlash Memory Cards
CF 1
D O N O T
R E M O V
N E TW O E D U R IN
R K O P E G
R AT IO N CF 0
Figure 5-52. This ejects the CompactFlash memory card partially out
and disconnect the power supply before you perform
Cisco 2900 Series and 3900 Series Hardware Installation Guide
Figure 5-52):
5-61