Installing And Removing Pvdm2S - Cisco 2900 series Installation Manual

Chapter 5 Installing and Upgrading Internal Modules and FRUs
Figure 5-17
2
1
Step 4 Insert the PVDM3 firmly into the connector until seated.
Step 5 Replace the chassis cover. For Cisco 2900 series ISRs replace the cover. See the
Replacing the Chassis Cover" section on page
"Removing and Replacing the Services Performance Engine" section on page

Installing and Removing PVDM2s

A PVDM adapter must be used to insert a PVDM2 into the PVDM3 slot. The PVDM adapter is a small
circuit board with connectors and clips that securely mount the PVDM2 into the PVDM3 slot. The clips
are on the side of the adapter and require physical manipulation to secure the module in place. The
following video clip shows how to install and remove a PVDM2 from the adapter.
http://cisco.com/en/US/docs/routers/access/2900/videos/PVDM/PVDM_Adapter.swf
•
•
•
•
OL-18712-03
Installing a PVDM3
Insert PVDM3 into connector
PVDM Adapter—Figure 5-18 on page 5-24
Clips and Guide Post—Figure 5-19 on page 5-25
Clips Open—Figure 5-20 on page 5-26
Clips Closed—Figure 5-21 on page 5-26
1
2 Snap retaining clips into place
5-4. For Cisco 3900 series ISRs replace the SPE. See the
Cisco 2900 Series and 3900 Series Hardware Installation Guide
Installing and Removing PVDM2s
2
"Removing and
5-6.
5-23