Removing A Dram Dimm - Cisco 2900 series Installation Manual

Installing and Removing DRAM DIMMs

Removing a DRAM DIMM

Follow these steps to remove a DRAM DIMM:
Read the
Step 1
perform any module replacement.
Remove the chassis cover. For Cisco 2900 series ISRs, see the
Step 2
Cover" section on page
Performance Engine" section on page
Locate the DRAM DIMM module. See the
Step 3
DRAM DIMM sockets on the router.
Step 4 Pull the latches away from the DRAM DIMM at both ends to lift the DIMM slightly. Pull the DIMM out
of the socket as shown in
Figure 5-9
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 5
Replace the chassis cover. For Cisco 2900 series ISRs, see the
Step 6
Cover" section on page
Performance Engine" section on page
Cisco 2900 Series and 3900 Series Hardware Installation Guide
5-14
"Safety Warnings" section on page 5-2
5-4. For Cisco 3900 series ISRs, see the
Figure 5-9.
Removing a DRAM DIMM
5-4. For Cisco 3900 series ISRs, see the
Chapter 5 Installing and Upgrading Internal Modules and FRUs
section and disconnect the power supply before you
"Removing and Replacing the Chassis
"Removing and Replacing the Services
5-6.
"Locating Internal Modules" section on page 5-7
"Removing and Replacing the Chassis
"Removing and Replacing the Services
5-6.
to find the
OL-18712-03