Cisco 2900 series Installation Manual page 176

Installing and Removing PVDM2s
Figure 5-18
1
2
1 PVDM adapter
3 Orientation notch
5 Guide posts
To install a PVDM2 into the PVDM3 slot, perform the following steps:
Read the
Step 1
perform any module replacement.
Ensure that both retainer clips are open (the UP position). (See
Step 2
Figure
Figure 5-19
Cisco 2900 Series and 3900 Series Hardware Installation Guide
5-24
PVDM Adapter Components
5
4
"Safety Warnings" section on page 5-2
5-21.)
shows the retainer clip, connector clip, and guide post locations on the adapter.
Chapter 5 Installing and Upgrading Internal Modules and FRUs
3
2 PVDM2
4 Guide post holes
section and disconnect the power supply before you
Figure 5-19,
5
4
Figure 5-20, and
OL-18712-03