Maintenance; Moving Your Bike; Installing New Computer Batteries; Adjusting The Drive Chain Or Belt Tension - Schwinn Airdyne Evolution Comp Owner's Manual


To move the Airdyne bike, carefully lift the rear end of the bike
and teer it to another location. Be gentle while moving the unit
as any sharp impact directly or indirectly to the computer can
affect operation
(Fig 6).

Your Airdyne/Evolution Comp computer comes complete with
fresh batteries already installed. Signs that battery power is
low include: fading LCD display; erratic function; or failure to
turn on when the ON/OFF button is pushed or when the pedals
Fig. 6
are put into motion. To install new AA batteries, just pop open
the battery door in the back of the computer (Fig. 7).

The drive chain and belt tension on your Airdyne bike have
been factory adjusted. They should not require any immediate
attention. If they need further adjustment at any point in time,
contact your authorized Schwinn dealer.

The fanwheel alignment on your Airdyne bike has been fac-
tory adjusted. It should not require any immediate attention. If
it does need further adjustment at any point in time, contact
Fig. 7
your authorized Schwinn dealer.

The Airdyne/Evolution Comp Bike can be leveled to compen-
sate for uneven surfaces. To level the bike, raise or lower
the four leveling bolts located on the underside of the legs by
screwing them in or out as needed (Fig. 8).

A locking device has been provided to prevent the drive
mechanism from rotating accidentally. To lock the Airdyne,
rotate the knob on the fan cage clockwise until the stop en-
Fig. 8 gages the fanwheel. It is now securely locked in place (Fig. 9).
To unlock the bike, rotate the knob counterclockwise
until the stop is completely clear of the fanwheel. To reduce
the risk of accidental injury, always engage the locking
mechanism when the bike is not in use. NOTE: if you hear a
clicking noise while exercising, make certain that the locking
knob is completely unscrewed and clear of the fanwheel.

Use a damp cloth to wipe your Airdyne/Evolution Comp Bike
and computer free of sweat. IMPORTANT: To avoid damaging
the finish on your Airdyne/Evolution Comp Bike and computer,
never use a petroleum-based solvent when cleaning. Avoid
Fig. 9
getting excessive moisture on the computer.
Moving Your Airdyne/Evolution Comp Bike

Installing New Computer Batteries

Adjusting the Drive Chain or Belt Tension

Fanwheel alignment

Leveling your Airdyne/Evolution Comp Bike
Locking your Airdyne/Evolution Comp Bike

Maintenance

17