Reinitialising Your Router; A.6 Reinitialising Your Router; Re-Establishing The Factory Configuration - Sagem 1201 Reference Manual

Annex A - Troubleshooting

A.6 Reinitialising your router

To Reinitialise your router, click button "Reboot" at the top right of the welcome page of your
HTTP configurator. When you click this button all the LEDs get off ; the "
in green and gets off then the "
starts. It lasts for around a minute.
Note : The green "
The "
A.7 Re-establishing the factory configuration
To undertake the procedure, there are two possibilities:
1) Using the HTTP configurator
•
In the welcome screen of your HTTP configurator, select the heading Management
followed by the sub-menu Restore Default in the Settings menu (cf. 5.10.1.3).
2) Using the "REG" button
• press the REG pushbutton for at least 15 seconds; all the LEDs get off; the "
(Internet) lights in green and gets off then the "
process for returning to the factory configuration starts.
This operation deletes the entire personalised configuration of your
router: Password, Configuration, etc. It lasts for around 2 minutes.
After a return to factory configuration, it is necessary to install your router again
using the installation CD-ROM, or to enter again the ADSL connection data supplied
by your Internet Service Provider (ISP) (cf. Internet Connection section - § 5.6).
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page A-8 Sagem Communication document. Reproduction and disclosure prohibited
" LED (PWR) lights in green and the initialisation process
" (LINE) and
" LED (Internet) lights in green if "PPP" link is established.
@
" (LAN) LEDs light if they are connected.
" LED (PWR) lights in green and the
" LED (Internet) lights
@
" LED
@