Annex E - Default Configuration; Default Username And Password; Default Configuration For The Local Network(Lan; Default Configuration For The Remote Network (Wan - Sagem 1201 Reference Manual

Annex E - Default configuration

This section indicates the values of the default parameters of your router when it
leaves the factory.
These default parameters can be modified by a particular preconfiguration of your
router.
E.1

Default username and password

The default access level is Administrator. Its associated "username" and "password" are:
Username
Password
E.2

Default configuration for the local network(LAN)

The following table gives the values of the principal LAN parameters of your router (ETH, USB):
LAN characteristics
ETH IP address
USB IP address
BROADCAST, ARP, MULTICAST
Router
NAT/PAT
E.3

Default configuration for the remote network (WAN)

Designation
VPI
VCI
Linking protocol
ADSL/ADSL2/ADSL2+
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page E-2 Sagem Communication document. Reproduction and disclosure prohibited
admin
admin
Value
192.168.1.1
8
35
PPPoA
DNS relay
DHCP server
Multimode
State
Internet and HTTP configurator access or
to a TV decoder
Internet and HTTP configurator access
Activated
The LAN traffic is routed to your ISP
Activated
Value