Recalling Memory Data; Clearing The Memory Data - A&D UA-853 Instruction Manual

Note: This device stores the last ninety measurements in memory. The data is
retained as long as the batteries are in the device. When you remove the
batteries or the batteries are drained, the data will be erased.
1. Press the MEMORY button.
2. The average data of all the measurements and
the number of data are displayed.
Then, each time the MEMORY button is
pressed, the memory data is displayed from the
most recent. After the last data is displayed, the
display returns to the clock display.
3. Press the following key to recall various data
when the average data of all the
measurements is displayed.
AM button
PM button
START button To display the clock.
When the MEMORY button is pressed at each display, the display returns
to the average data of all the measurements
For details on memory data recalling procedure, refer to the chart on the
next page.

Clearing the memory data

4. Press and hold the MEMORY button until the "
to clear the stored data.
Note: Pressing the START button while the memory data is displayed
initiates the UA-853 to start taking a measurement.

Recalling Memory Data

To recall the average data during the AM.
Then, each time the AM button is pressed, the memory
data taken during the AM is displayed from the most recent.
After the last data is displayed, the display returns to the
clock display
To recall the average data during the PM.
Then, each time the PM button is pressed, the memory
data taken during the PM is displayed from the most recent.
After the last data is displayed, the display returns to the
clock display
English 11
Press the MEMORY button
M
Averaged systolic
Averaged diastolic
Number of data
Average of
all the data
" (memory) mark blinks