Data In Memory; Storing The Data In Memory; Recalling The Memory Data; Erasing The Data In Memory - A&D UA-767PC Instruction Manual

Storing the Data in Memory

This device can automatically store up to 280 sets of measurement data in its
memory. If an error message appears, the measurement data will not be stored.
Whether the data will be stored or not after the measurement can be selected as
follows:
When the START button is pressed or the automatic power OFF function
works after a measurement, the measurement data will be stored in memory.
When the clock button is pressed after a measurement, the measurement
data will not be stored in memory.

Recalling the Memory Data

1. To access measurements stored in memory, wait until the device is in standby
mode.
2. Press and hold the START button until the display shows the most recent
measurement.
3. The display will show all of the stored measurements starting with the most
recent and then will return to standby mode.
To interrupt memory display, press the START button to initiate inflation mode.
To put the device in standby mode, press the START button again.

Erasing the Data in Memory

1. To erase measurements stored in memory, wait until the device is in standby
mode.
2. Press and hold the clock button until the buzzer sounds and the memory
access indicator blinks. All data in memory will be erased.

Data in Memory

English 13