Making Automatic Meter Measurements (For Models 190-Xx4) - Fluke 190-502/AM User Manual

Making Automatic Meter Measurements
(for models 190-xx4)
The test tool offers a wide range of automatic meter
measurements. You can display four large numeric
readings: R 1 ... 4. These readings are selectable
EADING
independently, and the measurements can be done on the
input A, B, C or input D waveform. In METER mode the
waveforms are not displayed. The 20 kHz HF rejection
Working with Noisy Waveforms
filter (see
is always on in the METER mode.
Selecting a Meter Measurement
To choose a current measurement for input A, do the
following:
1 Display the
METER
2 Open the Reading .. menu.
F1
Shop for Fluke products online at:

Making Automatic Meter Measurements (for models 190-xx4)

on page 27)
key labels.
METER
MyFlukeStore
www.
Using the Scope and Meter
3 Select the reading number to be
F1
displayed, for example
4 Select on A. Observe that the
highlight jumps to the present
ENTER
measurement.
5 Select the A dc... measurement.
ENTER
6 Select a current probe sensitivity
that matches the connected
ENTER
current probe (see Adjusting the
Probe Type Settings on page 16.)
You will see a screen like in Figure 12.
Figure 12. Meter Screen
1.877.766.5412
.com
1
1
READING
33