Gateway GT5448E - GT - 2 GB RAM Reference Manual page 49

www.gateway.com
8
If you are replacing an old drive, remove the four screws
that secure the hard drive to the hard drive bay, then
remove the hard drive from the bay.
Screws
- OR -
If you are adding a new drive (not replacing an old one),
remove the four screws (two on each side) from the
empty hard drive bay.
9
If you are replacing a drive, note any jumper settings
on the old drive and set the jumper on the new drive
to be the same. If you are adding a new drive, set the
jumper as instructed by the drive's user guide.
10
Slide the new drive into the drive bay, then secure the
drive to the bay using the four screws you removed
previously.
Jumper
Screws
43