Gateway E-9525R User Manual page 75

www.gateway.com
Moving the jumper while the power is on
can damage your server. Always turn off
the server and unplug the power cords
and all other cables before changing the
To reset the BIOS using the power and reset buttons:
Print the appendix for
1
Restart your server, then press F2 when the Gateway logo screen appears
2
during startup. The BIOS Setup utility opens.
Record any custom BIOS settings on your printout.
3
Press the reset button and hold it down for four seconds or more, then
4
press the power button while continuing to hold down the reset button.
Release both buttons at the same time. The BIOS is reset.
5
To reset the BIOS using the system board jumper:
Print the appendix for
1
Restart your server, then press F2 when the Gateway logo screen appears
2
during startup. The BIOS Setup utility opens.
Record any custom BIOS settings on your printout.
3
Follow the instructions in
4
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Follow the instructions in
Caution 5
Remove the jumper across pins 1-2 of header J3-B, then place the jumper
6
across pins 2-3.
jumper.
Follow the instructions in
7
Reconnect the power cords and turn on the server. The BIOS is reset.
8
Turn off the server, then disconnect the power cords and all other cables
9
connected to the server.
Follow the instructions in
10
"BIOS Settings" on page 101
"BIOS Settings" on page 101
"Preventing static electricity discharge" on
"Opening the server case" on page
"Closing the server case" on page
"Opening the server case" on page
Resetting the BIOS
in this guide.
in this guide.
31.
32.
31.
69