CHAPTER 2: Setting Up Your Server
14
Align the slots in the back server rails with the studs on the side of the
3
server, then engage the slots with the studs and slide the rail forward until
it stops.
Locking screw (installed)
Stud
Align the locking screw holes in the rails with the threaded screw holes
4
in the server, then install one locking screw through the each back server
rail.
Attach one mounting nut to each of the two front cabinet posts where
5
you plan to install the server.
Back server rail
Stud
(installed)
Front cabinet post
Mounting nut
www.gateway.com