Layer 2 Interface Configuration - ZyXEL Communications P-870H Series User Manual

Chapter 5 WAN Setup

5.4.1 Layer 2 Interface Configuration

Click the Add button in the Layer 2 Interface screen to open the following
screen. Use this screen to create a new DSL PTM interface. At the time of writing,
you can configure only one DSL interface on the ZyXEL Device.
Figure 29 DSL PTM Interface Configuration
The following table describes the fields in this screen.
Table 10 DSL PTM Interface Configuration
LABEL
Select
Connection Mode
Enable Quality Of
Service
Back
Apply/Save
58
DESCRIPTION
Select MSC Mode to allow multiple WAN services over a single virtual
circuit.
Select VLAN MUX Mode to allow multiplexing of multiple protocols
over a single virtual circuit. You need to assign a VLAN ID and priority
level to traffic through each WAN connection.
Select this option to activate QoS (Quality of Service) on this interface
to group and prioritize traffic. Traffic is grouped according to the VLAN
group.
The QoS setting applies to all WAN connections over the same PVC.
Click this button to return to the previous screen without saving any
changes.
Click this button to save your changes and go back to the previous
screen.
P-870H/HW Series User's Guide