Trigger Port Configuration - ZyXEL Communications P-870H Series User Manual

Chapter 8 Network Address Translation (NAT)
Table 39 NAT Trigger Port (continued)
LABEL
Server Name
WAN Interface
Trigger Start
Port
Trigger End
Port
Trigger Proto.
Open Start
Port
Open End Port
Open Proto.
Modify
Apply
Cancel

8.5.1 Trigger Port Configuration

This screen lets you create new port triggering rules. Click the Add icon in the
NAT - Trigger Port screen to open the following screen.
Figure 69 NAT > Trigger Port > Add
126
DESCRIPTION
This field displays the name of the service used by the packets for this
virtual server.
This field displays the WAN interface through which the service is
forwarded.
This is the first trigger port number that identifies a service.
This is the last trigger port number that identifies a service.
This is the trigger IP protocol. 1 means TCP, 2 means UDP and 3 means
TCP/UDP.
This is the first open port number that identifies a service.
This is the last open port number that identifies a service.
This is the open IP protocol. 1 means TCP, 2 means UDP and 3 means
TCP/UDP.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Remove icon to delete an existing rule. Note that subsequent
rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to return to the previous configuration.
P-870H/HW Series User's Guide