Installing Tooling; Removing Tooling - Grizzly G0751 Owner's Manual

Installing Tooling

Tool Needed
Wrench 19mm ................................................... 1
To install tooling:
1. disConneCt MaChine FroM poWer!
2. remove drawbar cap as shown in Figure 21.
drawbar
drawbar Cap
Figure 21. drawbar components.
3. align tooling alignment slot (see Figure 20)
with pin inside spindle, then insert tooling into
spindle until it contacts drawbar.
Note: Drawbar height inside spindle can be
changed by rotating the adjustment nut (see
Figure 21).
4.
Working from the top, hand-thread drawbar
into tooling until snug, then use a 19mm
wrench to tighten it.
Note:
DO NOT
Overtightening makes tooling removal dif-
ficult and could damage arbor and drawbar
threads.
5. re-install drawbar cap.
Model G0751 (Mfg. Since 1/13)
Qty
adjustment
nut
overtighten drawbar.

Removing Tooling

Tools Needed
Wrench 19mm ................................................... 1
Brass or dead Blow hammer ............................ 1
To remove tooling:
1. disConneCt MaChine FroM poWer!
2. remove drawbar cap, and only unthread
drawbar from tooling one full rotation.
Note: Do not fully unthread tooling from
drawbar, or drawbar and tooling threads
could be damaged during the next step.
3. tap top of drawbar with hammer to unseat
taper.
4. hold onto tooling with one hand and fully
unthread drawbar with the other hand.
Qty
-27-