Section 4: Operations; Operation Overview - Grizzly G0751 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0751 (Mfg. Since 1/13)
manual bEFORE
To complete a typical operation, the operator
does the following:
1.
examines workpiece to make sure it is suit-
able for cutting.
2. puts on protective gear.
3. securely clamps workpiece to table.
4. With machine disconnected from power,
installs correct cutting tool.
5. adjusts headstock height above table.
6. Checks range of table or spindle movement
to make sure setup is safe and correct for
operation.
7. selects correct spindle speed.
8. Connects machine to power and turns it ON.
9. Uses downfeed controls or table controls to
perform cutting operation.
10. turns machine OFF and waits for spindle to
completely stop before removing workpiece.
When tilting the head and returning it back
to 90°, you will need to tram the spindle with
the table to ensure that it is set perfectly.
Refer to the Tramming Spindle section on
Page 41 for detailed instructions.
-21-