Installing Tool Rest; Using Tool Jig - Grizzly T32720 Owner's Manual

Installing Tool Rest

The Model T32720 is equipped with a tool rest
that can be mounted vertically or horizontally. It
serves as an attachment point for jigs and other
accessories and provides a solid place to rest
workpieces. A micro-adjustment nut fine-tunes
the height of the tool rest, and the lock knobs at
each attachment point quickly secure the position.
To install tool rest:
1. DISCONNECT MACHINE FROM POWER!
2.
Insert tool rest into desired mounting holes
(see Figure 15). Refer to Grinding Wheel
Rotation on Page 23 to determine what posi-
tion is needed for grinding operation.
3. Turn micro-adjustment nut shown in Figure
15 to adjust tool rest height.
4. Tighten (2) lock knobs shown in Figure 15 to
secure tool rest position.
Micro-Adjustment
Nut
Lock Knob
(1 of 2)
Figure 15. Tool rest inserted in vertical mounting
holes.
Tool rest should never be placed in vertical
mounts for use with stropping wheel.
Working against wheel rotation will cause
severe damage to stropping wheel.
-20-
Tool Rest

Using Tool Jig

The tool jig is designed to secure a variety of tools
during operations to hold them steady for a good
flat edge.
To use tool jig:
1.
DISCONNECT MACHINE FROM POWER!
2. Slide tool jig onto tool rest (see Figure 16).
Tool Jig
Figure 16. Tool jig mounted on tool rest.
3. Insert tool between faces of jig clamp, as
shown in Figure 17, and tighten (2) tool jig
lock knobs.
Note: Set grinding tool angle before tighten-
ing lock knobs (refer to Setting Tool Angle
on Page 21).
Tool Jig
Lock Knob
(1 of 2)
Figure 17. Tool secured in tool jig.
Model T32720 (Mfd. Since 06/21)
Tool Rest
Tool