Installing Vertical Tooling; Installing Horizontal Tooling - Grizzly G0727 Owner's Manual

Installing Vertical
Tooling
For vertical milling, mount the motor-spindle
assembly in the vertical position, as shown in
Figure 22 on the previous page.
Tool Needed
Hex Wrench 10mm ............................................ 1
To install vertical tooling:
1.
DISCONNECT MILL FROM POWER!
2.
Use a clean shop rag and mineral spirits to
clean the mating surfaces of the tooling and
spindle, then allow them to dry.
Note: Any lint, oil, or debris left on the mating
surfaces of the tooling or spindle could inter-
fere with proper mating and increase runout.
When installing tooling, keep in mind that
the spindle rotates clockwise, as viewed
from the end where the drawbar is insert-
ed.
3. Align the slot in the tooling with the set screw
inside the spindle and fully seat the tool, then
hold it in place and thread the drawbar into it
from the top (see Figure 25).
Note: Only tighten the drawbar until it is
snug. Overtightening it could make removing
the tool difficult.
Figure 25. Installing tool vertically.
Model G0727 (Mfg. Since 7/11)
Installing Horizontal
For horizontal milling, mount the motor-spindle
assembly in the horizontal position, as shown in
Figure 23 on the previous page.
Qty Tool Needed
Hex Wrench 10mm ............................................ 1
To install horizontal tooling:
1.
DISCONNECT MILL FROM POWER!
2.
Use a clean shop rag and mineral spirits to
clean the mating surfaces of the tooling and
spindle, then allow them to dry.
Note: Any lint, oil, or debris left on the mating
surfaces of the tooling or spindle could inter-
fere with proper mating and increase runout.
Cutting tools are sharp and can quickly
cause laceration injuries. Always use a
shop rag or leather gloves when handling
mill cutting tools.
3.
Unthread the hex nut from the end of the
horizontal arbor, correctly position the cutting
tool and spacers on the arbor for the opera-
tion, then secure them with the hex nut (see
Figure 26 for an example).
Note: The horizontal arbor only accepts tools
with a
Figure 26. Example photo of a slitting saw
installed on the horizontal arbor.
Tooling
⁄ " bore.
5
8
Qty
-23-