Can Serial Decode - Agilent Technologies InfiniiVision 4000 X-Series User Manual

To display CAN serial decode, see
N O T E

CAN Serial Decode

To set up the oscilloscope to capture CAN signals, see
Signals"
For CAN triggering set up see
N O T E
To set up CAN serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 If the decode line does not appear on the display, press the [Serial] key
3 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
If the setup does not produce a stable trigger, the CAN signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the horizontal Zoom window for easier navigation of the
decoded data.
See Also
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
on page 385.
to turn it on.
decode data.
"Interpreting CAN Decode"
"CAN Totalizer" on page 391
"Interpreting CAN Lister Data"
"Searching for CAN Data in the Lister"
CAN/LIN Triggering and Serial Decode
"CAN Serial Decode"
"CAN Triggering" on page 387.
on page 390
on page 392
on page 393
on page 389.
"Setup for CAN
23
389