Troubleshooting - Motorola QIP7000 (P2) Series Installation Manual

Troubleshooting

5
Troubleshooting guidelines follow. If problems still occur after performing the
diagnostics, call the TRC for assistance as described in the Introduction.
Problem
The QIP set-top
will not power on
The remote control
does not work
There is no audio
when viewing
cable channels
QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual
574702-001 a
Table 8 – Troubleshooting Guidelines
Possible Solution
The QIP set-top may have received a software update and may not power on
while the new software is being installed. Try again in a few minutes.
•
Verify that the AC power cord is connected to the QIP set-top and an AC
outlet. Unplug the QIP set-top from the AC outlet, plug it back in, and then
press the POWER button.
•
If the QIP set-top is connected to a switched outlet on another unit, verify
that that unit is powered on. Unplug the power cord from the QIP set-top's
AC outlet, plug it back it in, and then press the POWER button. It is
recommended that you use an unswitched outlet, if possible.
•
Press the POWER button on the QIP set-top's front panel instead of the
remote control. The batteries in the remote control may be depleted.
•
Verify that the remote control is in "STB" mode.
•
Verify that there are no obstructions between the remote control and the
QIP set-top. Aim the remote control directly at the QIP set-top front panel,
not the TV or VCR.
The angle between the remote control and the QIP set-top may be too large.
Stand in front of the QIP set-top and not too far to either side.
•
Press and release operation keys one at a time, firmly and deliberately.
•
Try changing channels using the buttons on the QIP set-top front panel.
•
Check the batteries in the remote control. Install new batteries if needed.
•
Verify that the mute button on the QIP set-top or the remote control has
not been pressed. Press MUTE on the remote control to restore sound.
•
If the QIP set-top audio output is connected to the TV, verify that the mute
button on the TV has not been pressed.
•
If the QIP set-top audio output is connected to a home theater receiver,
verify that the receiver is set to the appropriate input source and the mute
button on the receiver has not been pressed.
•
Verify that you have the correct cables for the audio connections.
•
Verify that the audio cables are firmly connected between the QIP set-top
and the audio playback device (TV, receiver, DVD player, etc.).
This document is uncontrolled pending incorporation in a Motorola CMS
Troubleshooting
B
73