Adjusting Tof Position - Oki ML1120 User Manual

A TOF
DJUSTING
Use the following procedure to set TOF to accord with the
reference position (6.35 mm (0.25 in)). The reference position
refers to the first line of the paper i.e. the position to which the
printer feeds the paper when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous
forms mode.
1. Print out the menu settings of the printer as in
"Confirming current settings" on page 45
the TOF (in cut sheet mode or continuous forms mode) is
6.35 mm (0.25 in).
2. Set the Paper Type lever to the required paper type.
3. When continuous forms are used, place the paper on the
Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4. In continuous forms mode, press the LOAD/EJECT button.
In cut sheet mode, place the paper in the Paper Tray and
press LOAD/EJECT.
As the paper is taken into the printer, press the LF/FF
button and the paper is taken into the 6.35 mm (0.25 in)
position.
5. In off-line mode, press the following buttons to adjust the
first printing line:
To feed the paper forward by a small amount, press and
hold down the LOAD/EJECT button and then press the SEL
button.
To feed the paper backward by a small amount, press and
hold down the LOAD/EJECT button and then press the LF/
FF button.
NOTE
If the specified correction range is more than +- 0.366 mm
(1/144 in), the QUIET indicator flashes and the paper cannot
be moved.
ML1120/ML1190 User's Guide – Operating instructions > 56
POSITION
and confirm that