Installing The Sata Or Scsi Backplane - Intel Chassis SR1450 User Manual

Hardware Installations and Upgrades

Installing the SATA or SCSI Backplane

1. Observe the safety and ESD precautions at the beginning of this book. See
Information."
2. Power down the server and unplug all peripheral devices and the AC power cable(s).
3. Remove the chassis cover. For instructions, see
4. Remove all hot-swap drive carriers. For instructions, see
swap Hard Disk Drive."
5. Set the backplane board in place so that the holes in the board fit through the pegs in the bottom
of the server chassis. See letter "A" in the figure below.
6. Slide the board to the right until it stops. Do not pull on any components on the board – grasp
only on the edges of the board.
7. Tighten the blue captive screw at the center of the backplane board. See letter "B" in the figure.
Figure 48. Installing a SATA or SCSI Backplane into the Chassis
®
Intel Server Chassis SR1450 User Guide
"Removing the Chassis Cover."
A
B
"Safety
"Removing a SATA or SCSI Hot-
B
TP01607
65