Intel Chassis SR1450 User Manual page 59

Hardware Installations and Upgrades
15. Line up the holes on the replacement power distribution board with the power supply stand-offs
on chassis. See letter "A" in
and slide the power distribution board to the left until it sits firmly in place. See letter "B" in
"Figure 44".
16. Connect the main power, CPU power, and power signal from the power supply to the server
board. In "Figure
cable, and letter "E" shows the power signal cable.
17. Connect the power cable to the power distribution board (see letter "F" in
connect the power cable to the backplane (see letter "G" in
18. If a SATA backplane is installed, connect the SATA cables. See letter "H" in
19. Reconnect the power supply fans.
20. If a SCSI backplane is installed, connect the SCSI cables. See letter "I" in
21. Install the power supply modules. For instructions see
22. Install the power supply air duct. For instructions see
®
Intel Server Chassis SR1450 User Guide
L
K
K
Figure 43. Removing the Power Distribution Board
"Figure 44. Installing the Power Distribution Board".
44", letter "C" shows the main power cable, letter "D" shows the CPU power
C
E
Q
P
B
A
D
H
G G
I J
"Figure
"Installing a Hot-Swap Power Supply".
"Installing the Power Supply Air
F
TP01629
Press down
"Figure 44") and
44").
"Figure 44".
"Figure 44".
Duct".
59