Installing Or Removing A Floppy Drive (Slimline Or Standard); Figure 19. Inserting A Hot-Swap Hard Disk Drive Assembly Into The Chassis - Intel Chassis SR1450 User Manual

Server chassis

Hide thumbs Also See for Chassis SR1450:

Table of Contents

Hardware Installations and Upgrades

6. When the black drive carrier lever begins to close by itself, push on it to lock the drive

assembly into place.

7. (Optional) Install the front bezel. For instructions, see

Bezel."

Installing or Removing a Floppy Drive (Slimline or

Standard)

Floppy drives are installed in different ways, depending on the following items:

You want to install the floppy drive into the slimline drive bay.

You have installed a CD-ROM or DVD-ROM drive into the slimline drive bay. You want to

install the floppy drive into a bay that was intended for a hard drive (optional conversion kit is

required).

Look carefully at the heading titles below before beginning your installation to be sure you are

following the correct instructions for your system.

CAUTION

Floppy drives are NOT hot swappable. Before removing or replacing the

drive, you must first take the server out of service, turn off all peripheral

devices connected to the system, turn off the system by pressing the power

button, and unplug the AC power cord from the system or wall outlet.

Intel

Server Chassis SR1450 User Guide

TP01602

"Removing and Installing the Front

Table of Contents